Charging the Battery

Your PCS Vision Phone’s LiIon battery is rechargeable and should be charged as soon as possible so you can begin using your phone.

Keeping track of your battery’s charge is important. If your battery level becomes too low, your phone automatically turns off and you will lose all the information you were just working on. For a quick check of your phone’s battery level, glance at the battery charge indicator located in the upper-right corner of your phone’s display screen. If the battery charge is getting too low, the battery icon ( ) blinks and the phone sounds a warning tone.

Always use a Sprint-approved travel charger or vehicle power adapter to charge your battery.

Warning! Using the wrong battery charger could cause damage to your phone and void the warranty.

Using theTravel Charger

To use the travel charger provided with your phone:

1.Plug the travel charger into a wall outlet.

2.Plug the other end of the travel charger into the bottom of your phone (with the battery installed).

Charging when your phone is turned on:

The battery icon appears on the display while charging. The battery icon turns to when charging is complete.

Charging when your phone is turned off:

The battery icon appears, and the message “BATTERY CHARGING--Power Off--” is shown on the display while charging. When the battery is completely discharged, you may wait for several minutes until the message is shown on the display. The battery icon turns to , and the message changes to “CHARGING COMPLETE--Power Off--” when charging is complete.

It takes approximately 3.5 hours to fully recharge a completely rundown battery. With the Sprint-approved LiIon battery, you can recharge the battery before it becomes completely run down.

Section 2A: Your PCS Vision Phone – The Basics

16

Page 27
Image 27
Sanyo RL7300 manual Charging the Battery, Using theTravel Charger,  Charging when your phone is turned on