Setting Up Screen Call

This feature enables you to screen incoming calls by using a recorded announcement, either one that is pre-recorded or one that you have recorded. You can also record the caller’s message into the Voice Memo list.

Activating Screen Call

To start Screen Call when you have incoming calls:

When the phone rings or vibrates, press softkey) > Screen Call.

To setAuto Screen Call:

Options (right

1.Press Memo (right softkey) > Screen Call > Auto > On.

2.Set the answer delay by using numeric keys or by pressing the navigation key up or down.

3.Press or OK (left softkey). The icon is displayed on the Standby display.

Tip: While the caller’s message is being recorded, press to answer

the call, or press to stop recording and disconnect the call.

Selecting an Announcement for Screen Call

1.Press Memo (right softkey) > Screen Call > Announcement.

2.Depending on your preference, select Pre-Recordedor Custom.

Recording Name for a Pre-Recorded Announcement

1.Press Memo (right softkey) > Screen Call > Announcement.

2.Highlight Pre-Recordedand press Edit (right softkey) > Record Name.

If your name has already been recorded, select Yes or No for overwriting.

3.Press to start the 1st recording. (The maximum recording time is 12 seconds.)

4.Press to stop recording.

5.After the 1st recording, press again to start the 2nd recording.

6.Press to stop recording.

87

Page 95
Image 95
Sanyo SCP-7050 manual Setting Up Screen Call, Activating Screen Call, Selecting an Announcement for Screen Call