Sanyo VPC-AZ1E instruction manual Problem Cause Action

	Problem	Cause	Action	Reference
				page
Viewing	The image is too	The flash was blocked	Hold the digital camera
images	dark.	by a finger or other	correctly, and make sure	—
		object.	the flash is not obstructed.
		The subject was too	Capture the image in the
		far away.	range of operation of the	73
			flash.
		The subject was lit	Use the forced flash mode.
		from behind.	Use the exposure	81
			correction function.
		There is not enough	Adjust the shutter speed.	82
		light.	Adjust the ISO sensitivity	85
			setting.
	The image is too	The forced flash mode	Select a different flash	73
	bright.	is selected.	mode.
		The subject was too	Change the angle of the	—
		bright.	digital camera.
			Use the exposure	81
			correction function.
		The ISO sensitivity	Set the ISO sensitivity to	85
		setting is incorrect.	B.
	The colors of the	This is due to ambient	Capture the image using	73
	images captured	lighting.	the forced flash mode.
	indoors are not	The white balance	Set the white balance	86
	correct.	setting is incorrect.	setting correctly.
	Video clip picture is	The video clip was	Set the flicker reduction
	flickering.	filmed under	setting.	87
		fluorescent lighting.
	A part of the image	The hand-strap or a	Hold the digital camera
	is missing.	finger was blocking the	correctly, and make sure	—
		lens.	the lens is not obstructed.
		The image was	When capturing an image
		captured at close	at close range, use the
		range.	close-up alignment	72
			correction marks or
			compose the image using
			the LCD monitor.
	No image	This may happen	Play back images stored
	(?is displayed).	when trying to play	on a card using this digital
		back images stored on	camera.	101
		a card from a different
		digital camera.
	Vertical stripes	If a bright subject is	Not a malfunction.
	appear.	shot in the video clip
		shooting mode,		—
		vertical stripes may
		appear on the LCD
		monitor or in the image.

English 132