
Troubleshooting | F - 160 CE Operation and Maintenance Manual |
|
|
Problem: Delamination
Hints: • Check operating pressures
•Check operating speed
•Laminate compatibility with ink
•Ink compatibility with paper
W A R N I N G
Do not wear ties, loose fitting clothing or dangling jewelry while operating or servicing the laminator. These items can get caught in the nip and choke you or you can be crushed or burned.
7.3 Machine problems
Problem : No illumination to the control panel
Once the Hints are all checked, and your problem still exists, a service call must be placed for a qualified service personnel to fix the problem.
You may do this by dialing 1 ( 800 ) 790 - 7787. This will connect you with GBC National Service dispatch
. You will be required to give the serial number of your machine when placing a service call.
A space below has been provided to keep this number readily available if and when needed.
My Falcon 160 CE Laminator serial # is :
Hints : • Ensure an
•Press RESET.
•Confirm that the MAIN POWER is to the on position.
•Be sure power is supplied to the laminator
Problem : I can only operate in “Footswitch” mode.
Hints : • Be sure the tables are properly seated in the table brackets.
•Be sure the safety shields are in the down position.
•If the SAFETY indicator is flashing, place a service call.
Problem : I press GO, it will always be flashing.
At no time does GBC Films Group suggest or recommend that you attempt to fix the machine by removing the cabinets or leg covers yourself.
Hints : • Be sure the tables are properly seated in the table brackets.
•Be sure the safety shields are completely in the down position.
Page 7 - 4 | © GBC Films Group April 2000 |