F - 160 CE Operation and Maintenance Manual |
| Installation | |
|
|
| |
m) Turn the pull roller lift handle towards the rear | 4.9 | Connecting power | |
of the machine to lower the upper pull roller. | |||
|
|
Stop after initial contact with the lower pull roller plus 1/2 turn.
n)Raise the rear safety shield
o)Place the level across the top of the upper pull roller in the center. Refer to Figure 4.8.4
Drive to control side rear
Figure 4.8.4 Drive to control side rear
Level
ELECTRICAL
S H O C K
Only a qualified electrician should connect power to the laminator. You can be severely shocked, electrocuted or cause a fire if power is improperly applied.
a)Ensure the power at the junction box is in the OFF position.
b) Remove the drive side leg cover with a #2 phillips screw driver.
p)Verify all four leveling points. Make any adjustments neccessary. If all four points are leveled, secure all nuts in place.
q) Lower the front and rear safety shields.
r) Turn MAIN POWER to “OFF “.
© GBC Films Group April 2000 | Page 4 - 15 |
