GBC F - 160 CE manual Stop When pressed, stops the rollers and GO becomes white

F - 160 CE Operation and Maintenance Manual Operations

( 19 ) SAVE : When pressed and held ( approximately 4 seconds ), will beep and save the current settings for the number showing in the JOB DISPLAY. For more information, refer to Section 5.4 Job Programming on how to save parameters.

( 22 ) SPEED ▼: When pressed, decreases the speed of the laminator in increments of 0.5 ft/min. When pressed and held, speed will automatically decrease by 0.5 ft/min increments until it has reached 0 ft/min.

	19
	S E L	S A V
J O B 9	S T A N D B Y

00.0		G	O	F W D
				R E V
		S T O P
	S P E E D
	S AF ETY

22

( 20 ) SPEED DISPLAY : Displays the current speed setting of the laminator.

20

00.0		G	O	F W D
				R E V
		S T O P
	S P E E D
	S AF ETY

( 21 ) SPEED ▲: When pressed, increases the speed of the laminator in increments of 0.5 ft/min. When pressed and held, speed will automatically increase by 0.5 ft/min increments until it has reached the maximum allowed speed of 15 ft/min.

( 23 ) GO: When pressed, starts the rollers in motion. GO is solid. This solid indication is referred to as the “panel mode”. If a safety shield is raised during “panel mode”, GO and SAFETY ( refer to ( 27 ) SAFETY for explanation ) begin flashing enabling “footswitch” mode. ( refer to ( 28 ) FOOTSWITCH for explanation )

23

00.0		G	O	F W D
				R E V
		S T O P
	S P E E D
	S AF ETY

( 24 ) STOP : When pressed, stops the rollers and GO becomes white.

				21
15.0		G	O		F W D
					R E V
		S T O P
	S P E E D
	S AF ETY

00.0		G	O	F W D
				R E V
		S T O P
	S P E E D
	S AF ETY

24

© GBC Films Group April 2000 Page 5 - 5