F - 160 CE Operation and Maintenance Manual | Operations |
|
|
I N F O R M A T I O N
When the safety shield is in the lowered
position and "Footswitch" mode is engaged, speed is controlled through the control panel
I N F O R M A T I O N
If the variable speed footswitch is not close to the speed of the control panel, output quality may be affected by the speed difference.
Footswitch to Panel | To raise the safety shield |
2.To switch from “Footswitch” mode ( GO is flashing ) to “Panel” mode ( GO is solid ) with the safety shields in the down position. Perform the following steps;
•Press and hold the variable speed footswitch down.
•Press and hold GO for 3
•Release the variable speed footswitch.
•Release GO. GO should be solid.
3.In the event that the safety shield must be raised while the laminator is running, Perform the following steps;
W A R N I N G
When operating the laminator using the variable speed footswitch, keep hands and fingers away from the nip of the rollers. You may be CRUSHED or BURNED!
•Press and hold on the variable speed footswitch. ( approximately 1/2 the travel distance of the variable speed footswitch )
CAUTION
Speed is controlled through the variable speed footswitch when the safety shield is in the raised position.
© GBC Films Group April 2000 | Page 5 - 7 |
