F - 160 CE Operation and Maintenance Manual | Operations |
|
|
Section 5 Operations
The operator control panel for the Falcon 160 CE Laminator is located on the front of the machine, to the right of the front operating position.
For an illustration of the complete front control panel, please refer to Figure 5.1.1. The names and functions of these controls are as follows:
( 2 ) TOP TEMP DISPLAY : The display will show the set point temperature of the top main roller as the default display. When the top roller temperature has reached in the +/- 6 oF range of the set point, the display will be solid. When outside of this range, the display will flash.
TOP TEMP | BOT TEMP |
68 | 68 |
| 2 |
I N F O R M A T I O N
When any command is pressed on the control panel, a "beep" will sound. If the command is held down, the panel will "beep" only once .
5.1 Control Panel
( 3 ) TOP TEMP ▲ : When pressed, will increase the set point value of the top main roller in increments of 2 degrees. If held down, it will only increase to the maximum temperature setting of 290oF ( 143oC ).
| 3 |
TOP TEMP | BOT TEMP |
68 | 68 |
( 1 ) STANDBY: If flashing, the machine is in standby mode. This will occur after 3 hours of no activity. To wake the laminator from standby mode or manual engage standby mode, press STANDBY.
( 4 ) TOP TEMP ▼ : When pressed, will decrease the set point value of the top main roller in increments of 2 degrees. If held down, it will only decrease to the minimum temperature setting of 68oF ( 20oC ).
|
|
|
|
|
|
|
|
|
| S E L |
| S A V |
|
J O B | 0 |
|
|
|
|
|
|
|
|
| |||
| S T A N D B Y |
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1
TOP TEMP | BOT TEMP |
6 8 | 6 8 |
4
© GBC Films Group April 2000 | Page 5 - 1 |
