Operations | F - 160 CE Operation and Maintenance Manual |
|
|
5.3 Set up
d)Press machine RESET. The front control panel is illuminated.
Initial set up of the Falcon 160 CE laminator is easily attained when instructions are followed exactly. It is suggested and helpful if you take the time to read this section thoroughly before attempting to do any of the steps. A complete understanding of this section will enable you to follow the procedures descibed in Section 6.1 Application.
Machine reset
5.3.1 Power
a)Clear the area around the laminating rollers and pull rollers nip..
b)Ensure the laminator is plugged in.
c)Turn the MAIN POWER to the “ I ” position.
Power
ON/OFF
5.3.2 Film loading
W A R N I N G
Caution should always be exercised
when using the laminator with the safety shields raised.
You can be seriously HURT or INJURED!
a)Raise the rear safety shield if placing a roll of laminate onto the upper unwind shaft.
b)Lift the clevis pin located in the saddle of the upper unwind shaft.
Page 5 - 12 | © GBC Films Group April 2000 |
