SATO CT410, CT400 manual 9001069A Sato CT Series Printers

Section 4. Programming Reference

2.If the product of the values entered for “dd” and “ee” are not equal to or less than the value of “fff” (i.e.,“ffff” ≥ “dd” x “ee”), an error will occur and the symbol will not be printed. It is recommended that these values each be set to “000” and the printer be allowed to automatically calculate the optimum values.

3.The values for “dd” and “ee” need to be made larger if the security level is increased.

4.The maximum data length is 2700 characters, but may be less depending upon:

-the minimum module dimension (“aa”)

-the security level specified by “c”.

-the number of data characters

5.The Reference Point of the PDF417 symbol is the upper-left corner.

6.The <ESC>F Sequential Numbering command cannot be used with this command.

7.The <ESC>E Line Feed command cannot be used with this command.

8.The Macro and Truncated PDF417 symbols are not supported.

9.The values 00H thru 1FH can be specified as print data.

10.This command can be stored in a format.

11.The <ESC>R Rotate command can be used.

12.The print height of the symbol will vary depending upon the data specified; numeric only, alpha only or alphanumeric.

Page 4-80 9001069A SATO CT Series Printers