SATO CT410, CT400 manual Roll Guide so that the Paper, Fanfold Media

Section 2. Installation and Configuration

come off the top of the roll. The Paper Guides will automatically position the Roll Holders to suspend the roll.

7.Route the label material through the Paper Sensor Assembly and

over the Platen. Note that the
Sensor is part of the left Label
Roll Guide so that the Paper
Sensor is always positioned in the
same location relative to the left	Platen	Paper Sensor
edge of the label.

8.Close and latch the Print Head Assembly.

9.Press the LINE key so that the printer is in the OFF LINE mode and then press the FEED key. The label should advance to the next index (label gap or eye-mark) position.

Fanfold Media

1.Place the fanfold media behind the printer with the printing surface up.

2.Open the Top Cover by by pressing on cover release points located on each side of the printer. This releases the cover latch and allows it to swing upward on the rear mounted hinge points.

3.Carefully break out the Fanfold Access Panel from the back of the Top Cover.

4.Release the Print Head Assembly by pressing the Head Latch to the rear. This allows the assembly to rotate upward to the left allowing easy access for ribbon routing. Rotate the assembly until it is vertical.

Break Out for Fanfold Paper

5.With the Print Head Assembly in the up position, press the Paper Guide Release while adjusting the Paper Guides until they allow a media to fit between them. A millimeter scale is molded into the case to provide a guide when making the adjustment. The Paper Guides are center justified and interact with each other so that each moves an equal distance.

6.Route the label material through the Sensor Assembly and over the Platen.

Page 2-8 9001069A SATO CT Series Printers