SATO M-84PRO manual DO NOT remove the two outside, screws painted red on either

Section 4. Cleaning and Maintenance

7.Disconnect the signal and power cables from the print head connectors and set

the Print Head aside. There are two			Loosen thumb screw
connectors on the signal cable. The
smaller connector is used for the 203			Rotate to
and 305 dpi print heads, the larger one	Print Head
for the 609 dpi print head. Note which			open head
connector was connected to the print
head.
DO NOT remove the two outside
screws (painted red) on either			Signal Connector. Use
side of the center mounting
screw. The Print Head is pre-			correct size.
aligned and if these screws are		Print Head Connector
lossened, it will have to be re-
aligned for proper print quality.

8.Carefully attach the new print head to the connectors, using caution to make sure the connector keys are correctly positioned and that the correct cable connector is used. The connector on the print head should be the same size as the one you are replacing.

NOTE: Be careful not to scratch the printing surface of the print head while installing it. Scratching the surface will cause permanent and irreparable damage and is not covered by the warranty!

9.Align the thumb screw with the tapped hole in the new print head.

10.11. Re-secure the print head by tightening the screw.

SATO M-84PRO PN 9001105 Rev. A Page 4-5