REPRINT W/FEED
YES NO
FORWARD/BACKFEED DISTANCE DEFAULT
FORWARD/BACKFEED
DISTANCE XXXmm
EXT PIN 9 SELECT MODE1 MODE2
EURO CODE
D5
Section 3. Configuration
This selection specifies whether or not the printer will print the last printed label stored in memory when the FEED key is pressed in the Normal Online mode.
1.Use the LINE key to step the cursor to desired setting. If Yes is selected, the printer will reprint the last label when the FEED key is pressed when the printer is Online. If the printer is Offline, pressing the FEED key will feed a blank label.
2.Once the setting is correct, pressing the FEED key will accept the setting and advance to the
This display will only appear Backfeed is enabled
1.Use the LINE key to select either the Default or the Manual selection.
2.Once the setting is correct, pressing the FEED key will accept the setting and advance to the next display.
3.If Manual setting is selected, use the Cursor keys to advance the distance to the desired setting. Each time the LINE key is pressed, the Distance will advance 1 mm. The maximum distance is 255 mm.
4.Once the desired distance is set, press the FEED key to accept the setting and step to the next display.
This selection allows the user to select the conditions that cause the signal on Pin 9 of the EXT connector to be true. If Mode1 is selected, pin 9 will be true when the printer is ready to print, i.e. it is Online and has a print job loaded (a quantity of labels to be printed on the display). If Mode 2 is selected, pin 9 will be true if the printer is Online.
1.Use the LINE key to step the cursor to the desired setting.
2.Once the desired setting is selected, press the FEED key to accept the setting and step to the next display.
This selection allows the user to specify the dexadecimal code for the character which is replaced with the Euro Character. The default is D5H.
1.The cursor should be positioned over the first digit selection. Use the LINE key to step to the desired setting.
2.Press the FEED key to advance the cursor to the second digit of the desired hexadecimal code.
3.Press the LINE key to step to the desired setting.
4.When the setting is correct, press the FEED key to accept the setting and step to the next display.
SATO | PN 9001105 Rev. A | Page |
