SATO M-84PRO manual

Section 3. Configuration

Firmware Download (DSW2-6).Places the printer in the Firmware Download mode for downloading new firmware into flash ROM.

DSW2-6	SETTING
Off	Disabled
On	Enabled

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Protocol Code Selection (DSW2-7).Selects the command codes used for protocol control. Refer to page E-1 for more information.

DSW2-7	SETTING
Off	Standard
On	Non-Std

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Status Select(DSW2-8).For emulating earlier series software commands. Should be used only if problems are encountered when using existing software. This switch will also affect the settings selected by DSW1-7 and DSW1-8.

DSW2-8	SETTING
Off	Status 3 & 4 Enabled
On	Status 2 & 3 Enabled

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Backfeed Sequence (DSW3-1,DSW3-2).Backfeed is used to correctly position the label for application and then retract the next label to the proper print position. This operation can be performed immediately after a label is printed and used, or immediately prior to the printing of the next label.

			DSW3
DSW3-1		SETTING
			ON
Off	Off	Continuous
Off	On	Tear-Off	OFF
On	Off	Cutter*		1 2 3 4 5 6 7 8
On	On	Not Used

*Defaults to Continuous if cutter not installed

Page 3-4 PN 9001105 Rev. A SATO M-84PRO