SATO M8460S, XL400/410, M8490S, M-8400RV, M8485S, M8459S, CL408/412, CL608/612 Number, Bit CRC, Ascii

Programming Manual 4. Bar Code Specifications

Note:

1.If any of the parameters entered are outside the valid range, a symbol will not be printed when the <ESC>DC Print Data com- mand is sent to the printer.

2.The number of cells per line (eee) and the number of cell lines (fff) should be specified as all zeroes, allowing the printer to automat- ically calculate the optimum configuration for the symbol.

3.The Reference Point for the Data Matrix symbol is the upper-left corner. If an <ESC>R Rotate command is used to rotate the sym- bol, it will rotate in the counter-clockwise direction.

4.The Format ID specified for “aa” is defined by the following table. The printer only supports the Format ID’s defined in the table.

ID		ENCODING
Number	CHARACTER SET	SCHEME
	16 Bit CRC
01	Numeric, Space	Base 11
02	Upper Case Alpha, Space	Base 27
03	Upper Case Alpha, Space,Comma,	Base 41
	Period, Slash, Minus
04	Upper Case Alphanumeric, Space	Base 37
05	ASCII 7-bit, Full Keyboard (20H -7FH)	ASCII
06	ISO 8-bit, International (20H -FFH)	8-Bit
	32 Bit CRC
11	Numeric, Space	Base 11
12	Upper Case Alpha, Space	Base 27
13	Upper Case Alpha, Space, Comma,	Base 41
	Period, Slash, Minus
14	Upper Case Alphanumeric, Space	Base 37
15	ASCII 7-bit, Full Keyboard (20H -7FH)	ASCII
16	ISO 8-bit, International (20H -FFH)	8-Bit

5.The maximum number of data characters that can be specified for either the 16-Bit or 32-Bit CRC modes is 500.

SATO RISC Printers 153