SATO M8459S, XL400/410, M8460S, M8490S, M-8400RV, M8485S, CL408/412, CL608/612 manual Command Codes

Programming Manual 2. Command Codes

2.Command Codes

This section contains all the RISC printer Command Codes. The com- mands must be sent to the printer in an organized fashion in order for the label(s) to print.

The objective of this chapter is to explain the different commands and pro- vide examples of their usage, as well as to provide a detailed reference for programming the printers.

Each command begins on a separate page with its own heading. A uni- form layout is used to help you find key information about each command. For each Command Code in this section, there will be a sample data input stream to the printer and the expected print output. By studying the exam- ples, you can learn how to use the particular command within a whole block of printer code. Pay particular attention to the “Special Note” with each command to learn other important information.

The subject commands are highlighted in bold letters in the Reference Sheets. There are two parts of most, but not all, commands. The first is the command character which immediately follows the <ESC> code. It is always an upper case alpha or a special character (such as an “&” or a “%”). It is never a lower case alpha character. If the command requires additional variable information, it is represented by a group of lower case alpha characters immediately following the command character. For example, if an aaaabb is listed following the basic command, the printer will look for six characters immediately following the command. The first four would represent the value of aaaa and the next two the value of bb.

The maximum number of characters defined in a parameter is repre- sented by the number of characters shown in the command structure. For example, a command followed by an aaaa can have up to four characters. In general, commands with only one parameter following the command can be entered without the leading zeroes. However, certain commands require the exact number of matching characters. A command with two parameters listed following the command code without a comma delimiter, such as aaaabbbb require the exact number of digits to be entered. If the value of aaaa is “800” and the value of bbbb is “300”, then the parameters must be entered as “08000300”. It is recommended that you make it a practice to always enter leading zeros to prevent any mistakes.

Note:	These examples assume the use of the Standard Protocol
	Command Codes and a parallel interface. The labels for all
	printers will be similar, but, because of different resolu-
	tions and print widths may be larger or scaled differently.

SATO RISC Printers 21