Configuring the SDC 8000 system
Initialize Units 1 Manual Init
Full Init
Press ENTER to Save
Initialize Units 3 Load Defaults
Initialize Units 1 Manual Init
Manually initializing all conference consoles
If it is important that the conference consoles are assigned microphone numbers in a certain order, we recommend choosing the manual initialization.
From the central unit’s operating menu, choose “Conference”, “Initialize Units” and “Manual Init” one after the other.
The red signal light rings and the “Microphone active” LEDs on all conference consoles start flashing.
Note!
Only the signal light rings of the conference consoles start flashing while the signal light rings of the interpreter consoles remain dark! Initialization of the interpreter consoles is via the “Interpretation” menu.
Choose “Full Init”. | |
One after the other, press the MICRO key of all conference consoles |
in the order in which they are to be initialized.
As soon as the initialization of a conference console is accepted by the central unit, the red signal light ring of the console goes off.
Press the ENTER key to save this configuration.
Loading the
If necessary, you can load the
Attention!
Loading the
To load the
From the central unit’s operating menu, choose “Conference”, “Initialize Units” and “Load Defaults” one after the other. The text “Configuration will be overwritten. Continue?” is shown on the display.
Press the ENTER key to replace your current configuration by the
Adding a conference console to an already existing configuration
To add newly connected conference consoles to an already existing configuration:
From the central unit’s operating menu, choose “Conference”, “Initialize Units” and “Manual Init” one after the other.
The red signal light rings and the “Microphone active” LEDs on all conference consoles start flashing.
77
