Operating the components of the SDC 8000 system
34
Setting the channel to be output via the interpreter console’s built-in
loudspeaker
To set the channel (e.g. the floor channel or an interpretation channel) to
be output via the interpreter console’s built-in loudspeaker:
왘Press the LS CHAN key and keep it pressed.
왘While keeping the LS CHAN key pressed, press the “MENU왖” or
“MENU왔” menu selection key until the desired channel is shown on
the display.
Selecting an interpretation channel
To select an interpretation channel to be output via your headphones:
왘Press one of the keys RELAY 1, RELAY 2 or RELAY 3 and keep it
pressed.
왘While keeping one of the keys RELAY 1, REL AY 2 or RELAY 3 pressed,
press the “MENU왖” or “ MENU왔” menu selection key until the
desired language is shown on the display.
The pressed key RELAY 1, RELAY 2 or RELAY 3 is assigned the
interpretation channel with the selected language.
왘To listen to the interpretation channel assigned to one of the keys
RELAY 1, RELAY 2 or RELAY 3, press the corresponding key .
The LED next to the key lights up. The selected interpretation channel
is output via your headphones.
Using the interpreter console
As soon as your interpreter console is configured, yo u can use it as follows:
왘Make sure that the corr ect channel for the tar get language is set (see
“Switching between the A-channel and the B-channel” on page35):
yIf you interpret into the main target language assigned to your
booth, choose the A-channel.
yIf you interpret into a target language not assigned to your booth,
choose the B-channel.
In this case, make sure that the B-channel is configured to the
language into which you interpret (see “Configuring the B-channel of
an interpreter console” on page33)!
yIf you interpret a “rare” language into a language o f which the other
interpreters have a complete understanding and from which they
then interpret into their respective languages (Auto-floor), also
choose the B-channel.
The green LEDs indicate the selected channel (A or B).
왘Make sure that the selected channel is not being used!
The red “ENGAGED” LED of the selected channel must not light up!
왘Press the MICRO key and start interpreting.
The red LED of the selected channel lights up.
왘Press the MICRO key once more to stop interpreting.
The red LED of the selected channel goes off.