POWER ON AND OFF
The power switch is located on the left side of the machine.
POWER ON
Turn the power switch to the "ON" position
It will take about 45 seconds for the machine to warm up. While the machine is warming up, the POWER SAVE
indicator ( | ) will blink. |
(The POWER SAVE | |
indicator ( | ) will go off |
when the machine is ready to copy.)
However, you can make desired settings and press
the [START] key ( 
) during
POWER OFF
Make sure that the machine is not in operation and then turn the power switch to the "OFF" position.
If the power switch is turned off while the
machine is in operation, 1 a misfeed may occur and
the job that was in progress will be cancelled.
Check the following to make sure the machine is not in operation:
•The START indicator is lit. (Initial state)
•The POWER SAVE indicator (
) is lit. ("Preheat mode" or "Auto power
• | The machine reverts to the initial settings when it is first turned on, when the [CLEAR ALL] key ( | ) is pressed, |
Note | or when no keys are pressed for the preset "Auto clear time" following the end of a copy job. When the machine | |
reverts to the initial settings, all settings and functions selected to that point are canceled. The "Auto clear time" can be changed in the user programs. (p.38)
•The machine is initially set to automatically enter power save mode if not used for copying, printing, or scanning for a preset period of time. This setting can be changed in the user programs. (p.38)
Power Save Modes
The machine has two power save modes to reduce overall power consumption thereby reducing the cost of operation. In addition, these modes conserve natural resources and help reduce environmental pollution. The two power save modes are "Preheat mode" and "Auto power
Preheat mode
This function automatically switches the machine to a low power consumption state if the set duration of time elapses without the machine being used when the power is on. The POWER SAVE indicator (
) lights up, however, the keys on the operation panel can be used. Normal operation automatically resumes when a key on the operation panel is pressed, an original is placed, or a print job is received.
Auto power shut-off mode
This function automatically switches the machine to a state that consumes even less power than preheat mode if the set duration of time elapses without the machine being used when the power is on. All lights except the POWER SAVE indicator (
) and ON LINE indicator (
) go off. To resume normal operation, press the [START] key ( 
). Normal operation also resumes automatically when a print job is received or scanning is begun from a computer. While in auto power 
)) can be used.
Note The preheat activation time and the "Auto power
Initial settings
The machine assumes the initial settings when it is first turned on, when the [CLEAR ALL] key ( 
) is pressed, and approximately one minute after the last copy is made in any mode.
Copy ratio: 100%, Exposure: Automatic
Copy quantity: 0, All special copier modes: Off
Auto paper selection: On, Paper feed station: The tray selected in the "Default tray setting" in the user programs.(p.39)
15
