Installing the SAN Switch 2/8

Configuring SAN Switch 2/8 Network Addressing

Read the following sections for information on how to configure the SAN Switch 2/8 addressing scheme.

Requirements

The following items are required to set network addressing.

An IP address from your Network Administrator

SAN Switch 2/8 installed and connected to a power source

Serial cable (supplied with the switch) for connecting the switch to the workstation

A local workstation (desktop or notebook computer) with:

Microsoft® Windows 98, Windows 2000, Windows Millennium Edition, or Windows NT 4.0 operating system

RS-232 serial communication software (for example, ProComm Plus or HyperTerminal)

Ethernet cable for connecting the switch to the workstation or to a network containing the workstation

SFPs and cables, as required to connect the switch to the fabric

Setting Network Addresses via a Serial Connection

Use the following steps to verify or change the SAN Switch 2/8 IP address, subnetmask, or gateway address.

Note: During first time setup, you must replace the factory IP, subnetmask and gateway addresses with addresses provided by your Network Administrator.

1. Remove the shipping plug from the SAN Switch 2/8 Serial port.

hp StorageWorks SAN Switch 2/8 Installation Guide

47

Page 47
Image 47
HP AA-RSB6B-TE manual Configuring SAN Switch 2/8 Network Addressing, Requirements