Managing the SAN Switch 2/8
Note: Year values greater than 69 are interpreted as
Displaying Switch Configuration Settings
Use these steps to display the system configuration settings.
1.Log in to the switch as the admin user.
2.At the command line enter the following command: configShow
The system configuration settings are displayed.
SAN Switch 2/8 Diagnostic Tests
Read the following sections for information on using POST and diagnostic tests.
Interpreting POST Results
Each time the switch is powered on or reset, the switch automatically performs POST, a one minute system check during which the port status LEDs flash different colors.
To determine whether POST completed without errors, verify that all LEDs return to a normal state after POST is complete. If one or more LEDs do not return to a normal state, and this is not due to the switch being set to beacon, refer to the hp StorageWorks Fabric OS V3.0.x/V4.0.x Procedures User Guide.
Note: If the switch prompt does not display when POST completes, POST was not successfully completed and the switch should be returned to your switch supplier for repair.
Any errors detected during POST are written to the system log, accessible through the errShow command. For more information about error messages, refer to the hp StorageWorks Fabric OS V3.0.x/V4.0.x Procedures User Guide.
70 | hp StorageWorks SAN Switch 2/8 Installation Guide |
