Air Filter Cycle
Air Filter Cycle can be changed from the factory setting of 100 hours to
* Suppose you want to set the cycle to 250 hours.
ProcedureDisplay
CUSTOM | 8 | 2 |
HELP x 2 |
10.Multiplication Factor for Double/Triple Quantity The multiplication factors of the double and triple quantities for memory cooking are preset to 1.80 and 2.60. You can check or change the multiplication factors.
*Suppose you want to know the multiplication factor for double quantity with memory 1, and change it to 2.00 in any Memory Input Method.
1 Press the CUSTOM HELP | After about 1 sec. | |||
pad twice within 2 seconds |
|
|
|
|
and enter 8, 2. |
|
|
|
|
|
|
|
| |
| CHECK | |||
|
|
|
|
|
SELECT
TIME
2 Press the SELECT TIME pad.
Procedure
CUSTOM | x2/x3 |
HELP x 2 |
1Press the CUSTOM HELP pad twice within 2 seconds and press the DOUBLE/TRIPLE QUANTITY pad.
Display
NO. CHECK
2 
5 
0
3Enter desired time.
(Ex : Enter 2, 5, 0 for 250 hours).
0
1
2 Enter memory number.
NO. CHECK
NO. CHECK
START
4 Press the START pad to save settings.
STOP
CLEAR
5Press the STOP/CLEAR pad to exit from the Custom Help Function.
9.Selecting Operation in case of Magnetron Failure
Your oven has 2 magnetrons. In case of single magnetron failure, the oven can be used until servicing by changing settings to allow operation under single magnetron only. However, check food carefully as additional cooking time will be needed when operating with a single magnetron.
CH91 : Yourovendoesnotworkwhenonemagnetron fails = Factory setting
CH92 : Your oven works even if one magnetron fails.
To set magnetron failure options
Press the CUSTOM HELP pad twice within 2 seconds then enter the numbers
9, 1 to stop operation when one magnetron fails 9, 2 to allow operation of one magnetron only
Press the START pad to save settings and the STOP/ CLEAR pad to exit from the Custom Help Function.
After about 1 sec.
CHECK
SELECT
TIME
3 Press the SELECT TIME pad.
2 
0 
0
4Enter desired multiplication. (Ex : Enter 2, 0, 0 for 2.00.)
START
NO. CHECK
5Press the START pad to save settings.
STOP
CLEAR
6Press the STOP/CLEAR pad to exit from the Custom Help Function.
