Sharp VC-H680X Setting the Channels, Or* 0, Press Menu, Normal, ~...~~..--.~---..-.--. I Screen

	Setting the Channels		0
l”y, “VIIvu,, ,~Vc.IYt, “I II		, and Ui-ii channeis 28 to 69. Your VCR has 48 programmabie
Vn,,r \/f-R ,-z,n ~orni>in \/UC chafinels 0 to j2

channel positions, each of which can be set to any of the above broadcast channels, The channel positions have been preset at the factory as shown below.

. Use the A / V / 4 / F buttons on the remote control to set the OSD.

• Channel position numbers 0, 1, 3 to 6, 8, 11 to 27, and 29 to 47 have been factory set to be skipped when CHANNEL A or V (CH A or V) is used.

• If the picture is not clear, if you want a different channel from the one oreset or if vou wish to reset a skiooed

Skipped channels

AUTO TUNING

PREPARATION

channel, reset the channel as follows

•Select the video channel on your TV and turn on the VCR. (See page 5, item 3.)

A SET

Or* 0 7

-----I

CHANNEL PRESET

0 Press MENU.

Select item “CHANNEL PRESET” withA/Y, and press

SET.

@ Select item “AUTO” withA/Y and press SET

A 7

MANUll

*“TOMnTiC TUNING. PLE?.SE WATT.

SET

Normal

@ The channel display on the TV screen will continue

through all of the channels and when finished, the TV

screen will return to the normal screen.

The bar display indicates the estimated amount of

~...~~..--.~---..-.--. I) Screen

channels tuned.

•If additional unwanted channels were found, refer to page 16 to skip unwanted channels

•If some channels were unable to be found, refer to Manual Tuning on page 15.

14