Tape Remaining Display

The tape remaining display only works with tapes recorded in PAL. It does not work with tapes recorded in NTSC.

On Screen Display

VCR Display

Select FULL or COUNTER display mode by pressing

MODE OSD on the remote control

 

*

• Press DISPLAY on

REM I:05

the remote control.

 

This function accurately displays the tape remaining only for tapes recorded in PAL mode. (It does not accurately

display the tape remaining for tapes recorded in NTSC mode.)

0 \rcihen you insert the tape and the VCR IS in the stop mode, the tape remalnrng cannot be computed. The followrng indrcator is shown when the tape remaining has not yet been computed or cannot be computed

lOSD1

VCR display]

REM

When you start recording or playback, the VCR will begin the computation. However, this may take some time. When computation IS completed, tape remaining will be shown on the OSD and VCR display for 5 seconds.

If the “REM.” mode is selectedwrth MODE OSD or DISPLAY and the VCR is in stop mode, the tape will automatically fast forward or rewind for a few seconds and then the VCR will begln computrng the amount of tape remaining.

During computation, REC will not function, and pressing STOP, PLAY/x2, or other buttons will interrupt the computation.

Setting the DPSS or ZERO-BACK function during computation may cancel it.

The indicated length of tape remaining is only an approximate guide.

This function may not properly work for video tapes other than E-60, E-90, E-180 and E-240.

The length of tape remaining during fast forward or rewind may be indicated as greater than it actually is.

When m and CFii!%l tapes are used with a cassette adapter, the indication may not be correct.

Warning for the length of tape remaining

When the tape reaches the point where only about five minutes of recording time is left, the remaining length of tape will be automatically displayed, as a warning.

No warning, however, will be shown during timer recording or Simple Recordrng Timer recording

37

Page 37
Image 37
Sharp VC-H680X operation manual Tape Remaining Display, On Screen Display, Mode OSD on the remote control