Playback

Auto Tracking Control System

This function automatically adjusts the tracking to match the recorded tape. Auto tracking engages in the following cases:

*When you insert the cassette and begin playback.

When you press CHANNEL A and ‘I(CH A and v) at the

same time.

Poor tracking

Normal tracking

*When the VCR has been playing back an unrecorded section of tape, and

then reaches a recorded tape

segment.

 

 

 

When auto tracking engages, ” .” on the TV screen flashes for a few seconds.

 

 

When a poorly recorded tape is played back, auto tracking may not operate normally. In this event, manually adjust the tracktng with CHANNEL A/v (CH A/v) to make any noise disappear.

Auto Head Cleaning System

When the tape is inserted or ejected, this system automatically cleans the drum and heads with a special roller before recording or playback begins, protecting the heads and drum from dirt and preserving beautiful picture quality.

Quick Start with Full Loading Mechanism

Your VCR has a standby function (Full Loading Mechanism) to allow immediate recording and playback. After pressing REC or PLAY/XS, it takes about 2 seconds until recording or playback is engaged when in the standby mode.

Auto Rental Mode

(This function only works when AUTO RENTAL mode on the MODE selection screen is set to ON.)

The convenient auto rental mode lets you enjoy playback with ease. When you insert a cassette with the erasure protection tab removed (rental videos, etc.), your VCR automatically turns on the power, winds the tape forward to find the recorded section, and plays back the tape. When the tape reaches the end of recorded section, the VCR automatically rewinds the tape, ejects it and turns into POWER STANDBY mode.

If there is more than a 15 second unrecorded section between recorded sections, the tape will automatically stop and rewind. To watch the next recorded section, press STOP fast forward to that section and play the tape.

If the erasure protection hole is covered, press PLAY/x2 after the power turns on automatically. (Auto Rental Mode does not work.)

If Auto Rental and Repeat (Auto Repeat) modes on the MODE selection are set to ON simultaneously, Auto Rental will not

function. (if thls happens, set Repeat (Auto Repeat) mode to OFF.)

*The AUTO REPEAT mode has priority over the AUTO RENTAL mode. If the AUTO REPEAT mode is set to ON and the video cassette reaches its end, the VCR will rewind the tape and play it back again without ejecting the tape or turning into POWER STANDBY mode

21

Page 21
Image 21
Sharp VC-H680X Auto Tracking Control System, Auto Head Cleaning System, Quick Start with Full Loading Mechanism