Siemens 2011 Checking your own telephone’s signalling method, Setting dial pulsing, @33x

18.7.99 kap02.fm5 Gigaset 2011 Comfort, GBR: A30852-X1106-B307-1-

Step by step guide to putting into service

Step 6: Check the signalling method

Telecom telephone lines can operate with the following signalling methods:

●Dial pulsing (DP)

●Dual-tone multifrequency signalling (DTMF)

Your Gigaset 2011 is set to DTMF signalling by default.

Checking your own telephone’s signalling method

Press the Talk key. You will hear the dial tone (on-hook sig-

cnal).

Press any digit, e.g. 2. If you can still hear the dial tone

o(on-hook signal), you must set the signalling method to dial pulsing (DP).

Setting dial pulsing

Press the menu key on the keypad.

. Press the left display key until Service is displayed. Press the right display key for OK to confirm your selec- tion.

Initiate the procedure.

#1

Enter the four-digit base code; (factory default: "0000")

o(➔ page 43).

uREDIAL

@33x		Set dial pulsing (DP).
	SET

The settings "DTMF/Flash" or "DP" are only needed to operate your Gigaset 2011 at the main station telephone.

The other signalling method settings are intend- ed for operating Gigaset 2011 in telephone sys- tems (➔ page 47).

Gigaset 2011 is ready for operation.

4