Siemens 2011 operating instructions Operating at more than one base station

18.7.99 kap17.fm5 Gigaset 2011 Comfort, GBR: A30852-X1106-B307-1-

Operating at more than one base station

Operating at more than one base station

You can register and operate your handset at up to 6 Gi- gaset base stations (as of Gigaset 1010 and Gigaset 2010 and higher).

This offers the following advantages:

●You can operate the same handset at base stations in different geographical locations (e.g. in the office and at home).

●You can extend the range or the area in which you can call with the same handset in large areas by placing the base stations in suitable locations.

Please note the following when operating at more than one base station:

● Ongoing calls are interrupted or cleared down when you move from one base sta- tion radio range to another.

● Internal calls can only be made within the ra- dio range of a base station, i.e. not to hand- sets that are in another base station radio range.

● If you are out of range of a base station for several minutes, and your handset is switched on, then when you re-enter the range it may take up to 20 minutes to "find" the base station again. In such cases, switch the mobile unit off for a minute and then on again.

We recommend following the procedure below:

●Register your handset at the required base stations (➔ page 69) and assign the required base station numbers (1 to 4). Register your handset at all base stations with the same internal call number, provided this is not yet assigned.

You can see which base station your handset is currently using at any time on your handset display. Note the in- structions for naming handsets on ➔ page 73.

74