Quick Setup Menu 9300 Series User’s Guide
Page 30 Chapter 2 - Using The Front Panel
Quick Setup Menu
Select QUICK SETUP from the Setup menu to access to the Power Meter module and
the Communications module settings. These settings are all configured when the
meter is initially put into service — typically you will not need to change these
settings once the meter is operational.
Comm 1, Comm 2, and Infrared Comm Menus
The setup registers for the three serial Communication modules are as follows:
1The factory set Unit ID is based on the serial number of the meter.
Refer to the online ION Programmer’s Reference for details on each Communications
module’s additional registers and their default settings.
Profibus Comm Menu (9300)
In addition to the existing communications ports available on the 9300 meter, the
9300-Profibus option is equipped with a Profibus port capable of operating at baud
rates up to 12 Mbps. You must configure the 9300-Profibus before the meter can
provide power system data to the Profibus network.
The Comm 4 Profibus Communications module has one setting: PB Address. The
default value of this register is 126. Use the front panel to configure this setting to
a unique PB Address on your Profibus network.
Register Default Value Description
CM1 Unit ID Factory Set 1The communications ID for COM 1
CM1 Baud Rate 9600 The baud rate of the COM 1 port
CM1 Protocol ION The communications protocol for COM 1
CM2 Unit ID Factory Set 1The communications ID for COM 2
CM2 Baud Rate 9600 The baud rate of the COM 2 port
CM2 Protocol ION The communications protocol for COM 2
IR1 Unit ID Factory Set 1The communications ID for the Infrared port
IR1 Baud Rate 9600 The baud rate of the Infrared port
IR1 Protocol ION The communications protocol for the Infrared port