Description of the equipment

6.6Hardware reset

There is a reset button on the back cover of the network camera (see chapter 6.2 Front and rear views of the camera, No. 5). It is used to reboot the network camera or to reset the network camera to the factory default configuration. Depending on the functional problem, rebooting may set the network camera back to normal state. If the problem remains after rebooting, restore the network camera settings to the factory default and install the software again.

Reboot:

Press and release the reset button. The status LED on the front will blink red.

Restore:

Press the reset button continuously until the status LED on the front blinks in red and green simultaneously. Note that all settings will be reset to factory default.

 

17

 

 

Siemens Building Technologies

 

Fire Safety & Security Products

05.2009

Page 17
Image 17
Siemens CCIC1410 configurationmanual Hardware reset, Reboot, Restore