SmartBridges sB3416-01, sB3416-02 manual Ethernet Bandwidth Control sB3416-03 only

i n t e l l i g e n t w i r e l e s s p l a t f o r m

Figure 3-3 airClient TOTAL Wireless Bandwidth Control (sB3416-03)

3.2.2. Ethernet Bandwidth Control (sB3416-03 only)

Note: This section is only applicable for 3416-03.

sB3416-03 allows you to limit the amount of bandwidth for each device connected on the Ethernet side, to allow for proper sharing of the bandwidth. The bandwidth on the Ethernet side can be limited based on the IP address of the device, or its MAC address.

Follow the steps below to control the Bandwidth parameters on the Ethernet side, based on IP address:

1.From the navigation menu bar, click on Networking Bandwidth Control.

2.In the Ethernet Bandwidth Control settings, click on the Enable Bandwidth BWC button to enable the Ethernet bandwidth controlling feature.

3.To control the Ethernet BWC, based on the IP address, enter the IP address of the PC in the IP Address field and keep the MAC address as 00:00:00:00:00:00.

4.You can configure the upload and download limit separately (in kbps), as shown below in Fig 3.4

5.Click on the Add button to add the entry in the table below.

6.Click on Save to save the settings. The settings will take effect after the Reboot.

airClient™ TOTAL 3416 User Guide Page 55 of 74