Adjusting the volume of the subwoofer(s)

1 Press (SOURCE) to select a source (tuner, CD, or MD).

2 Press (SOUND) repeatedly until “SUB” appears.3 Press < or , to adjust the volume.

After three seconds, the display returns to the normal playback mode.

Tip

When you press (VOL) repeatedly to adjust the volume all the way down, “Sub ATT” appears and the cutout frequency of the subwoofer is disabled.

Adjusting the frequency of the subwoofer(s)

To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency (see the diagram below), the subwoofer(s) will output only low frequency signals so you can get a clearer sound image.

Level

Cut-off frequency

 

Frequency (Hz)

1 Press (MENU).

2 Press (MENU) repeatedly until “SUB LPF” appears.

3 Press (ENTER).

4 Press < or , to select the desired cutoff frequency.

The cut-off frequency in the display changes as follows:

62 y 78 y 99 y 125 y 157 y off

5 Press M or m to adjust the volume.

6 Press (MENU) twice.

After the frequency setting is complete, the display returns to the normal playback mode.

Listening to each programme source in its registered DSO— Source Sound Memory (SSM)

Each time you return to the same source, you can hear the same DSO menu and equalizer curve registered for that source, even after changing the programme source or turning the unit off and then on again.

31