and Location 2 Chapter

Lower control panel unlock button

To close the lower control panel

Push up the folding levers on both sides at the same time.

Note

When closing the lower control panel, be careful not to catch your fingers in the panel.

Parts of Function

2-1-1 Upper Control Panel

1POWER switch

2REMOTE buttons and RS-232C indicator

3 EJECT button

Cassette compartment

Z

4PHONES jack and control

aPOWER switch

Pressing the “ j ” side of the switch powers the unit on. When the unit is powered on, the LCD (see page 14) lights.

bREMOTE buttons and RS-232C indicator

Press the 1 (9P) button or 2 (50P) button to select the device controlling this unit.

1(9P): This unit is controlled by a device connected to the REMOTE 1-IN(9P) or REMOTE 1-OUT(9P) connector. The button lights when pressed.

2(50P): This unit is controlled by a device connected to the REMOTE 2 PARALLEL I/O(50P) connector. The button lights when pressed.

RS-232C indicator: This indicator lights when this unit is communicating with a device connected to the RS- 232C connector.

cEJECT button

To eject the cassette, press this button. While the cassette is being ejected, this button lights.

Note

Ejecting with the EJECT button is a local operation. It is not possible to eject a cassette in another VTR by remote control.

dPHONES jack and control

Connect stereo headphones with an impedance of 8 Ω, to monitor the sound during recording, playback and editing. The control knob adjusts the volume.

It is possible to set an internal board switch so that the output volume from the MONITOR OUTPUT L and R connectors is controlled simultaneously.

For details, refer to the Installation Manual.

12 2-1 Control Panels