bHDSDI (HD Serial Digital Interface) OUTPUT connectors (BNC type)

Output HD format video/audio signals.

When the setting of F5 (CHARA) in function menu page P04: MISC-1 is “ON”, connector 3 (SUPER) outputs a signal with superimposed timecode, menu settings, alarm messages and other text information.

cSDI (Serial Digital Interface) OUTPUT connectors

 

 

(BNC type)

 

 

 

 

Output D1 format video/audio signals.

 

 

 

2Chapter

 

When the setting of F5 (CHARA) in function menu page

 

signal with superimposed timecode, menu settings, alarm

 

 

P04: MISC-1 is “ON”, connector 3 (SUPER) outputs a

Location

 

messages and other text information.

 

5Power supply section

Parts of Function and

 

 

 

 

 

 

 

 

1 AC IN connector

 

 

 

 

 

 

 

 

2 Ground terminal

aAC IN (AC power input) connector

Use the supplied power cord to connect this to an AC outlet.

bGround terminal Connect this to ground.

6External device connectors

REMOTE 2 PARALLEL I/O(50P)

1 REMOTE 2 PARALLEL I/O(50P) connector

REMOTE 1-IN(9P)

REMOTE 1-OUT(9P)

RS232C

VIDEO CONTROL (9P)

2 VIDEO CONTROL(9P) connector

3 REMOTE 1-IN(9P) connector

4 REMOTE 1-OUT(9P) connector

5 RS232C connector

aREMOTE 2 PARALLEL I/O(50P) connector (D- sub 50-pin)

Connect remote control signals from an external device.

For details, refer to the Installation Manual.

bVIDEO CONTROL(9P) (digital video processor

control) connector (D-sub 9-pin)

For remote control of the internal digital video processor, connect the optional HKDV-900 Video Remote Controller.

Always power off this unit before connecting the video remote controller.

cREMOTE 1-IN(9P) (remote control signal input)

connector (D-sub 9-pin)

When using this unit together with another HDCAM VTR, and a BVE-series BVE-700/900/910/2000/9000/9000P/ 9100/9100P or other editor, connect the optional 9-pin remote control cable from the other unit to this connector. Depending on the setting in setup menu item 211, you can use this connector alone, or in a loop-through configuration with the REMOTE 1-OUT(9P) connector.

dREMOTE 1-OUT(9P) (remote control signal

output) connector (D-sub 9-pin)

This provides the loop-through output for remote control signals from the REMOTE 1-IN(9P) connector. Depending on the setting in setup menu item 211, you can use this connector alone, or in a loop-through configuration with the REMOTE 1-IN(9P) connector.

24 2-2 Connector Panel