5-3 Special Automatic Editing Methods
This section describes the following automatic editing methods:
•Quick editing
•Continuous editing
•Standalone editing
•Preread editing
5-3-1 Quick Editing
After selecting the edit mode, you can reduce editing time by setting the edit points and executing the editing at the same time.
Use the following procedure.
Editing 5 Chapter
1,2,3 2,3
1 Select F6 (R/P SEL) in function menu page P06: EDIT to select the player or the recorder, and stop the tapes on both the player (PLAYER) and recorder (RECDER) at the positions you want to make the respective IN points.
2 Holding down the SHIFT/ENTRY button, select F1 (AUTOEDIT).
Editing starts.
3 While monitoring the editing on the monitor, hold down the SHIFT/ENTRY button and select F10 (OUT) at the position you want to make the edit OUT point.
Editing ends.
The point at which you started the editing will be the IN point, and the point at which you ended the editing will be the OUT point.
To preview
In step 1, after setting the recorder or player edit IN point, hold down the SHIFT/ENTRY button and select F2 (PREVIEW).
5-3-2 Continuous Editing
After an automatic editing, the recorder automatically returns to the OUT point.
For the second and subsequent editing operations, you can continue editing by simply specifying the IN and OUT points on the player. In this case the current OUT point on the recorder will be the new IN point.
OUT point of previous editing =
IN point of current editing
Recorder
Previous edit segment | Current edit segment |
Player
IN point |
| OUT point |
After automatic editing of one edit segment, to carry out continuous editing use the following procedure.
1 Set the player IN and OUT points.
Recorder OUT point for the previous editing will be the new IN point.
2 Holding down the SHIFT/ENTRY button, select F2 (PREVIEW) in function menu page P06: EDIT to carry out the preview.
3 Holding down the SHIFT/ENTRY button, select F1 (AUTOEDIT).
Editing starts.
When the editing is completed, the recorder stops at the OUT point, and the player stops 2 seconds after the OUT point.
By repeating this procedure, you can carry out continuous editing.
By setting setup menu item 326, you can make the previous OUT point automatically will be the new IN point.
5-3-3 Standalone Editing
This refers to editing using an external device as the player which cannot be remotely controlled via the REMOTE1- IN (9P) or REMOTE
52