1 In function menu page P07: E.PRESET, select the desired function from F2 (INS TC), F3 (INS CUE) and F6 (INS VID) to F10 (INS A4).
2 In function menu page P06: EDIT, select F6 (R/P SEL) to select the VTR you want to set edit points.
3 Rotate the search dial in jog or shuttle mode to find the edit point.
For details of jog/shuttle mode playback, see the sections “Playback in jog mode” (page 37) and “Playback in shuttle mode” (page 37).
4 Holding down the SHIFT/ENTRY button, select F9 (IN), F10 (OUT), F7 (AUD IN) or F8 (AUD OUT) to set an edit point.
When the edit point is set, the selected button changes from flashing to continuously lit.
5 Repeat steps 2 to 4 to set the required edit points.
As each edit point is set, the corresponding button changes from flashing to continuously lit.
Note
During split editing, if you set six or more edit points for the recorder and player, F7 to F10 (AUD IN, AUD OUT, IN and OUT) begin to flash. Editing cannot be carried out in this state. Delete unnecessary edit points using the ALT/ DELETE button.
For details of how to delete edit points, see the section “To delete an edit point” (page 46).
To set the edit points automatically in split editing
Split editing requires a total of eight edit points: four video edit points (player IN and OUT and recorder IN and OUT) and four audio edit points (player audio IN and OUT and recorder audio IN and OUT).
Once any five of these points are defined, the system automatically calculates and sets the remaining three points.
Specifically, once you have set three of the four video edit points and two of the four audio edit points, the remaining three edit points are set automatically, regardless of whether these points are for the recorder or player.
In the figure below, the edit points shown within boxes are already set. Other edit points (recorder audio OUT point, and player audio IN and video OUT points) are set automatically.
Note that any edit point can be deleted or corrected later regardless of whether it was set manually or automatically.
Audio IN point |
| IN point | Audio OUT point | OUT point |
|
|
|
|
|
Recorder
Player
Audio IN point | IN point |
| Audio OUT point | OUT point |
|
|
|
|
|
You can set audio cut in, crossfade, fade in, and fade out |
| |
| ||
| ||
effects, including their durations, by menu selection. |
| |
| ||
| ||
| ||
For details, refer to the Installation Manual. |
| |
| ||
| ||
5Chapter | ||
editing of audio only | ||
When the audio IN point is not set for insert | Editing | |
preview or editing. In this case, the current tape position is | ||
As long as the audio OUT point is set, the VTR is ready for |
| |
automatically used as the audio IN point. |
| |
To use a VTR without a split editing function as |
| |
the player |
| |
When it is not possible to set audio and video edit points |
| |
individually on the VTR you are using as the player, you |
| |
can carry out split editing by setting the audio IN and OUT |
| |
points and three video edit points on the recorder (this |
| |
unit). |
|
You can display the time data for an edit point in the time data display (see page 17).
The edit points IN, OUT, AUDIO IN, and AUDIO OUT are displayed in the ancillary message display.
1,2
45 | |
|
|