Note

Audio, video, and CTL signals need to be recorded in advance in the insert editing section on the tape. If the section in which these signals are not recorded correctly is used for insert editing, noise or breakup can occur in the audio and video when that section is played back.

To start automatic editing

When you finish setting the edit points, with F1 (AUTOEDIT) flashing, select F1.

F1 changes from flashing to continuously lit, and the automatic editing begins.

At the end of the automatic editing, F1 goes off.

After automatic editing, to correct the edit points and reexecute the edit

Hold down the ALT/DELETE button and select F1 (AUTOEDIT) to recall the edit points. After adjusting the edit points select F1 to carry out the edit again.

For details of how to correct edit points, see Section “5-1-5 Modifying and Deleting Edit Points” (page 46).

F1

(AUTOEDIT)

SHIFT/ENTRY button

F2

(PREVIEW)

 

F3

(REVIEW)

 

ALT/DELETE button

To change the OUT point during automatic editing

After starting the automatic editing, hold down the SHIFT/ ENTRY button and select F10 (OUT) before the preset OUT point. The position where F10 was selected becomes a new edit OUT point, and editing ends.

To abandon automatic editing

Press the STOP button.

The automatic editing before reaching the OUT point is interruped. At the same time, F2 (PREVIEW) and F1 (AUTOEDIT) start flashing, and the unit returns to the state before the editing was started.

The edit IN and OUT points are preserved so that you can carry out a preview or automatic editing operation again by holding down the SHIFT/ENTRY button and selecting F2 or F1.

To review the editing results

After editing, you can check the editing results on the monitor.

To carry out a review, hold down the SHIFT/ENTRY button and select F3 (REVIEW) before you set any new edit point or modify any existing edit point.

The F3 lights, and the review is carried out.

At the end of the review the F3 goes off, and the tape returns to the OUT point and stops.

Editing 5 Chapter

5-1 Automatic Editing

49