Rear Panel

1VIDEO IN connectors and 75-ohm termination switches

 

 

 

 

 

2 VIDEO OUT connectors

 

3POWER switch

 

 

VIDEO IN

 

 

VIDEO OUT

 

 

 

 

13

9

5

1

S VIDEO

 

POWER OFF

ON

 

 

 

 

 

 

14

10

6

2

A

 

 

⁄AC IN

 

 

 

 

 

15

11

7

3

B

 

 

 

 

16

12

8

4

 

 

 

 

OFF

ON OFF

ON OFF

ON OFF ON

 

PARALLEL I/O

RS-232C

 

 

75Ω

75Ω

75Ω

75Ω

 

 

 

 

 

6 AC IN connector

5 RS-232C connector

4 PARALLEL I/O connector

Overview 1 Chapter

1VIDEO IN (video input) connectors (BNC type) and 75-ohm termination switches

For connecting video cameras.

Connectors 1 to 4 are provided as the standard inputs. Connectors 5 to 16 can be added, four additionally connectors for each optional HSRA-11 input board mounted.

The termination switches are normally used in the ON position.

For mounting an input board, see the instruction manual for the HSRA-11.

2VIDEO OUT (video output) connectors S VIDEO (luminance/chroma signal output) connector (4-pin): Outputs Y/C-separated S video

signals. Connect via a cable to the S video input of a video monitor.

A (A image output) connector (BNC type): Outputs composite video signals for monitoring. Character signals are superimposed on the output signal depending on the settings made on the Indication Control menu (page 4-8).

B (B image output) connector (BNC type): Outputs composite video signals. The signal to be output is normally the same as that from the A connector.

The Image Control menu (page 4-6) permits you to specify use of this output exclusively for a specific camera. Note that the character signal is not superimposed with such usage.

3POWER switch

For turning on/off the power to the recorder.

4PARALLEL I/O connector (37-pin)

Used to input/output various control signals or to supply control voltages.

You can use 24 pins for inputs and 8 pins for outputs. The functions of these pins can be assigned from the Remote Control menu (page 4-13).

5RS-232C connector (9-pin)

Connect an editor or computer, via an RS-232C cable.

6AC IN connector

Connect an AC power source via the supplied AC power cord.

Chapter 1 Overview 1-9