Preparations and Connections 5 Chapter
Settings
3 Highlight MONITOR (or display Monitor), and press the bkey to move to the lower layer.
Example: A Image to Monitor
SETUP MENU
IMAGE CONTROL MENU
A IMAGE
MONITOR : MANUAL
M* MANUAL AUTO
4 Select AUTO (Auto) by pressing the vkey, and return to the upper layer (in step 2) by pressing the
Bkey.
To set the cycle for automatic change
The cycle is set to 5 seconds at the factory. You can change it in the range of 1 to 60 seconds in units of seconds.
1 Perform step 1 of “To activate the automatic change function,” highlight AUTO CYCLE (or display AutoCycle) in the layer of step 2, and press the bkey.
The menu shifts to setting the auto change cycle.
AUTO CYCLE SET
CYCLE : 5SEC
ABORT : MENU KEY
DATA SET : SET KEY
2 Set the cycle by pressing the Vor vkey.
3 When the settings are completed, press the SET key.
A message “NOW SAVING” is displayed, and the settings are stored in nonvolatile memory.
The Image Control menu is restored.
To restore the previous settings
Before pressing the SET key, press the MENU key. The message “ABORT !” is displayed, and the previous settings are restored.
Setting the Recording Modes
What’s recording mode?
Up to five
Requirements specified in a recording mode: CAMERA NUMBER: Cameras to be used for
recording
TAPE LENGTH: Tape length of the cassette to be used
IMAGE QUALITY: Picture resolution
TIME MODE: Time to record on a single cassette
REC CYCLE: Time to record per camera
The settings are made with “Setting of Rec Mode” of the Recording Function menu.
To select the Recording mode setting displays
1 Highlight REC FUNCTION MENU of the Top menu by pressing the Vor vkey, then press the b key.
The Recording Function menu is displayed.
SETUP MENU |
|
REC FUNCTION MENU |
|
NORMAL REC | : MODE 1 |
TIMER REC |
|
ALARM REC |
|
REPEAT REC | : OFF |
CONTINUOUS REC1) | : OFF |
SETTING OF REC MODE
1)
Chapter 5 Connections and Preparations |