Notes

You cannot record over existing material. The recorder automatically starts recording from the end of the existing material.

Make sure that the remaining recordable time on the CD-R or CD-RW is longer than the playing time of the CD, especially if you want to record all the tracks on the CD.

You cannot pause recording in Synchro-Recording.

If you set “Program Play,” you cannot use the High Speed Synchro-Recording mode for recording.

When you select the High Speed Synchro Recording mode during Program Play, the recorder will automatically make a copy at normal speed.

You cannot use the recording function when you set “Shuffle Play.”

If an error message appears on the front panel display, refer to “Error Messages” on page 55.

With the following kinds of CDs, you may experience a reading failure or noise when recorded to a CD-R or CD-RW.

CD with adhesive labels attached to them

Irregularly shaped CDs (for example, heart or star shaped)

CDs with printed text concentrated on one side only

Old CDs

Scratched CDs

Dirty CDs

Warped CDs

When “TOC WRITE” flashes in the display, the recorder is currently updating the table of contents (TOC). Do not move the recorder or pull out the AC power cord.

If the following occurs during CD playback or recording, a reading error may occur or noise may be produced in the recorded results:

The CD tray or other part of the system is bumped.

The system is placed on an uneven or soft surface.

The system is located near a speaker, door, or other source of vibration.

Do not disconnect the recorder from

the power source immediately after

recording.

If you do, recorded material may not be saved to the CD-R or CD-RW. When “BUSY” or “UPDATE” appears in the display, the deck is currently updating track information. When “UPDATE” stops being displayed, it is safe to disconnect the AC power cord.

48US

*RCD-W7V.p65_46-5348

Recording on a CD-R or CD-RW disc Manually

You can start recording from the end of the existing material.

When using the remote, set SELECT to DECK B for operations on DECK B. To perform Synchro-Recording, see “Recording a CD to CD-R or CD-RW disc at Normal Speed” on page 46 or “Recording a CD to CD-R or CD- RW disc at High Speed” on page 46.

INPUT REC z

REC LEVEL

z

1 Turn on the amplifier and set the input selector to the position for the sound source you want to record.

2 Place a recordable CD-R or CD-RW on DECK B.

3 Press INPUT repeatedly to select the input connector.

To record through

Select

DIGITAL OPTICAL IN

OPTICAL

 

 

ANALOG IN

ANALOG

 

 

4 Press REC z.

The recorder stands by for recording.

Note

The manual recorording from DECK A is not available, so use syncro recording method. Refer to page 46-47.

12/9/01, 6:10 PM

RCD-W7V 4-236-407-11(1)

Page 48
Image 48
Sony RCD-W7V Recording on a CD-R or CD-RW disc Manually, 48US, Press REC z, Recorder stands by for recording