Setting the preset codes (continued)
4Select the component name you want the Remote Commander to preset by pressing the Label key (in this case, TV).
TV
The “TV” and current preset code (in this case, “8001”) appear as the Label keys.
“0” - “9,” “CLEAR” and “POWER” flash.
LEARN | PRESET | POWER |
NG |
1 2 3
4 5 6
7 8 9
0
CLEAR
TV8001
Note
If another remote control signal has already been learned, the delete confirmation message appears. Register the components after deleting the learned signal following the procedure of the LCD display.
SU
LEARN
NG PRESET
DELET LEARN? | YES | NO |
5Press the “8,” “0,” “1,” and “1” number keys.
Tip
Each time the CHANNEL +/– button is pressed, the preset code increases/ decreases by 1.
If you make a mistake in inputting
Press the CLEAR key. The preset code returns to the previous number.
6Press the OK button.
OK
A beep sounds and the input preset code appears on the Label key momentarily.
SU
LEARN
NG PRESET
TV | TV 8011 OK |
“PRESET” appears as the Display title.
SU
LEARN
NG PRESET /1
TV
7Press and hold the COMMANDER OFF button for more than 2 seconds.
COMMANDER
OFF
The Remote Commander turns off.
46