ProblemSolution
Even if you operate an XPRESS function, the Source component does not turn on, or it turns off.
•The Remote Commander memorizes the status of the component's input selector and power on/off. However, if you turn on/off the component with the remote control or operate the component directly, it will not recognize the current component status. In this case, press
•If the TV turns off by its own Sleep function, the Remote Commander does not recognize its status. Turn off the TV with the Remote Commander. You can also turn off the TV at the scheduled time with the Timer on the Remote Commander.
Even if you operate an XPRESS function, the input selector of the TV or RCVR (Receiver/Amplifier) does not achieve the correct status.
•The Remote Commander memorizes the status of the component's input selector and power on/off. However, if you turn on/off the component with the remote control or operate the component directly, it will not recognize the current component status. In this case, press the
•If the TV turns off by its own Sleep function, the Remote Commander does not recognize its status. Turn off the TV with the Remote Commander. You can also turn off the TV at the scheduled time with the Timer on the Remote Commander.
Make sure to slide your finger from the | |
properly. | If you slide other than from the |
| the action. |
Trouble with setting mode
ProblemSolution
You cannot operate the component even after you programmed a preset code.
•Set the preset code correctly. If the preset code that is listed first for your component does not work, try all the preset codes for your component in the order listed in the supplied “Preset Code Lists.”
•Some features may not be preset. If some or all of the keys do not function correctly even after you have set the preset codes, use the learning function to program the remote control signals for the component (page 47).
•If you set a component code after changing the label of a component, they are cleared and return to the original label. Change the label of a component after you decide the component to be used by presetting a code.
Information Additional
You cannot operate a | Make sure that the Remote Commander has learned the correct |
component even after you | signals. See “For accurate learning” (page 51) and try the learning |
programmed remote | procedure again (page 48). |
control signals with the |
|
“learning” function. |
|
“NG” flashes 5 times when | • Leaning has not succeeded. After checking the following, try the |
learning. | learning procedure again (page 48). |
| – Change the distance between the Remote Commander and |
| remote control. |
| – See “For accurate learning” (page 51). |
| • The preset codes cannot be set. See the supplied “Preset Code |
| Lists” and try setting the preset codes again (page 45). |
Continued 73