Programming a series of actions with just one button (continued)
If you want to quit before finishing
Press and hold the COMMANDER OFF button for more than 2 seconds. The setting is canceled, and the Remote Commander turns off.
If you want to return to the previous display
Press the BACK button or the COMMANDER OFF button.
Notes
•If you interrupt the procedure at any point for over 2 minutes, the setting is cancelled and the series of actions (a macro) will be programmed to that point. In this case, clear the program (page 54) and start again from step 1 to set the entire program from the beginning. You cannot continue from where you left off.
•If you set the preset code (page 45) or program a new signal by learning (page 47) on a key or button that has been programmed in the System Control macro, the new signal will be transmitted when you press the corresponding SYSTEM CONTROL button or System Control key.
•If you try to program more than 32 steps, the System Control macro programming finishes, and the 32 steps you have programmed are registered. If you want to program again, clear the program (page 54) and start again from step 1.
About the order of operation steps
Some of the components may not accept consecutive remote control signals. For example, a TV generally does not react to the next signal immediately after the
TV
To clear programmed series of actions for SYSTEM
CONTROL button or System Control key
1While pressing the COMMANDER OFF button, press the MUTING button.
COMMANDER
OFF
MUTING
“SET” appears as the Display title.
SU
LEARN | SET | /1 |
NG |
PRESET LEARN MACRO TIMER
2Press “MACRO” on the Label keys.
MACRO
“MACRO” appears as the Display title.
SU
LEARN
NG MACRO
SYSTEM XPRESS
54