If you want to quit before finishing
Press and hold the COMMANDER OFF button for more than 2 seconds. The previous status returns, and the Remote Commander turns off.
If you want to return to the previous display
Press the BACK button or the COMMANDER OFF button.
Notes
•When you finish setting the timer standby mode, the “” mark stays lit beside the clock. This means that one or more Timers are activated.
•The timer program you set repeats every week until you set the timer standby mode to OFF (weekly timer). If you want to execute the timer program only once, set the timer standby mode to OFF after the execution of the timer program.
Executing a series of actions with just one button
– System Control function
LEARN
NG
|
|
|
|
| System Control |
X PRESS | BACK | COMPONENT | COMMANDER | keys | |
| LIGHT OFF | ||||
EPG |
| MENU | VOLUME | CHANNEL | SYSTEM |
|
|
| |||
| OK |
|
|
| CONTROL |
EXIT |
| TOOLS |
|
| buttons |
|
|
| MUTING | RECALL |
|
SYSTEM CONTROL |
|
|
| MORE button | |
1 2 | 3 4 | MORE | ALL OFF |
IMPORTANT
The Timer function of this Remote Commander is designed for use with AV components.
Do not use the Timer function with other components, such as an air- conditioner or other electrical appliances. It may cause a fire or a serious injury.
The Remote Commander has special buttons which can be programmed to perform a series of actions (a macro) by pressing just one button.
If you press the MORE button (rightmost SYSTEM CONTROL button), all keys sharing the same function as that SYSTEM CONTROL button appear at the bottom of the display. These keys are called, “System Control keys.”
You can program a series of actions (a macro) for each of four SYSTEM CONTROL buttons and four System Control keys. This is called “System Control macro.”
How to set the System Control function
For
provided in “AX Remote Editor.”
For
“Programming a series of actions with just one button” on page 51.
Operating
Continued 31