Setting up for your PC (continued)
For Windows XP users
1Close all software running on Windows.
2Insert the supplied
After a moment,
3Click [Exit] to close
4Connect the PC and the Remote Commander using the supplied USB cable (page 19).
“Found New Hardware” appears in the Notification Area in the lower
Tip
If the following confirmation appears, “Can Windows connect to Windows Update to search for software?” appears, select [No, not
this time], then click [Next].
5Select “Install the software automatically [Recommended]”, then click [Next].
Installing of the USB driver starts. “Completing the Found New Hardware Wizard” appears when the installation is complete.
6Click [Finish].
For Windows 2000 users
1Close all software running on Windows.
2Insert the supplied
After a moment,
3Click [Exit] to close
4Connect the PC and the Remote Commander using the supplied USB cable (page 19).
“Found New Hardware” appears. After a moment, “Found New Hardware Wizard” appears.
5Click [Next].
“Install Hardware Device Drivers” appears.
6Select “Search for a suitable driver for my device [recommended]”, then click [Next].
“Locate Driver Files” appears.
7Mark only the check box of “CD- ROM drives”, then click [Next].
“Driver Files Search Results” appears, and the found driver is displayed.
8Click [Next].
Installing of the USB driver starts. “Completing the Found New Hardware Wizard” appears when the installation is complete.
9Click [Finish].
Installing of the USB driver finishes.
18 | Installing of the USB driver finishes. |