Notes
•If you have already programmed the VOL +/– or MUTING button for each component with any signals using the Learning function, the procedure above will not change the function of the VOL +/– and MUTING buttons.
•If you have programmed volume control signals on VOL +/– or MUTING buttons of TV or AMP, you can only use that signal when you select TV or AMP. For other components, the preset volume control signals for TV or AMP (depending on the above setting procedure) will be transmitted. To use the new signals, you need to program each button for each component by the Learning procedure (page 15).
— System Control Function
With the System Control function, you can program a series of operating commands, and execute them by pressing just one button. For example, when you watch a video, a series of operations like that below would be necessary.
Example:
1Power on the TV.
2Power on the video (VCR).
3Power on the amplifier.
4Set the input selector of the amplifier to VIDEO 1.
5Set the input mode of the TV to
VIDEO.
6Start video playback.
You can program up to 16 consecutive operation steps to each of the SYSTEM CONTROL 1, 2 or 3 buttons.
A procedure that calls for pressing 2 buttons is counted as 2 steps. Pressing a Component Select button is also counted as 1 step. If you have set the System Control function on a Component Select button (page 27), the execution of the programmed commands begins when you press the Component Select button for more than 2 seconds.
Continued
23