Programming a Frequently Used Key Operation for SYSTEM CONTROL Buttons (continued)

3Press SYSTEM CONTROL 2.

The S (set) indicator flashes (Learning function standby).

If other functions have already been “learned” by that button

The S (set) indicator flashes twice, and the Commander returns to its state in Step 2.

Either “teach” to another SYSTEM CONTROL button, or clear the already “learned” function (page

37)and start over from the beginning.

remote control of air-conditioner

during data transfer

data transfer complete

4Press the ON/OFF button on the remote control of the air-conditioner until the Commander reacts as shown below.

During data transfer, only the S (set) indicator stays lit and the Component buttons turn off.

After data transfer is complete, the Commander returns to its state in Step 2.

5Press S (set) to finish setting.

Note

You can program a remote control signal for a SYSTEM CONTROL button by “learning” for which the System Control functions have been programmed. In this case, the System Control functions are overwritten and cannot be used. If you clear the “learned” signal from the button (page 37), the System Control functions are restored, and you can use them again.

36