3While holding cursor V pressed, press the Number 1 button.
The S (set) indicator flashes and all Component Select buttons light up.
6Press ENT (ENTER) on the sending remote Commander.
As the data is received, the corresponding Component Select buttons light up one by one.
If data transfer has been unsuccessful during or after the procedure, the S (set) indicator and all Component Select buttons flash five times, and the Commander returns to its state in Step 5. Either try again from Step 6, or press S (set) to cancel data receival.
4Confirm that the sending remote commander is ready for data transfer.
(To set the sending commander, follow the procedure on page 38.)
Note
Be sure that the sending remote commander is ready to transfer data.
Note
If you do not perform Step 6 within 10 seconds, the S (set) indicator and all Component Select buttons flash five times, followed by a short pause, and then flash again.
5Press ENT.
The S (set) indicator lights up and all Component Select buttons turn off
Continued
41