Sony RM-VL900 Receiving the data

Transferring Data between Remote Commanders (continued)

5Press ENT (Start data transfer).

After the data is transferred, the Component Select button turns off.

If data transfer has been unsuccessful during or after procedure, the S (set) indicator and the selected Component button flashes five times, and the Commander returns to its state in Step 3. Either try again from Step 5, or press S (set) to cancel data transfer.

Notes

•The data of the “learned” signal and the System Control function programmed on a Component Select button cannot be transferred.

You can use the Learning function (page 15) to program the “learned” signal and the System Control function programmed on a Component Select button on another remote commander.

•Be sure that the receiving remote commander is ready to receive data.

Receiving the data

This Commander can receive the data of another Sony RM-VL900 or RM-AV2100.

To receive the all data from another remote commander

1Place the RM-VL900 head to head with another remote commander.

Another remote commander

about 2 – 4 inches
(5 – 10 cm) away	RM-VL900

2Press and hold S (set) for more than 3 seconds.

The S (set) indicator lights up, and all Component Select buttons flash.

40