To clear the “learned” remote control signal

While holding S (set) pressed, press one of the SYSTEM CONTROL 1, 2 or 3 button.

The S (set) indicator and all Component Select buttons light up when you press these buttons, and turn off when you release them.

Notes on the “learned” signals of an air- conditioner

About seasonal adjustments

If you change the settings of the air-conditioner for the season, you have to program the remote control signals of the new settings on the Commander.

If the power-on/off operation does not work correctly

The air-conditioner may not be turned on or off properly with the button of this Commander to which you have programmed its power-on/off signal.

If the Commander can operate only “ON” with one button and “OFF” with another, while your air-conditioner’s remote control can operate “ON/OFF” with a single button, program the signal on two buttons of the Commander as follows.

1Clear the “learned” power-on/ off signal.

(In the example on page 35, clear the “learned” signal from the SYSTEM CONTROL 2 button.)

2Program the signal (transmitted from the power-on/off button of the air-conditioner’s remote control) for the SYSTEM CONTROL 2 button again.

3Program the signal from the same button of the remote control for another button (for example, the SYSTEM CONTROL 3 button).

The two buttons of the Commander have been programmed with the power-on signal and the power-off signal of the air-conditioner respectively, so that you can operate the air- conditioner with the Commander.

37