3Press the Component Select button for the desired component.
The selected Component button lights up, and all other buttons turn off.
4Press the Number buttons to enter the
The selected Component button turns off each time you press a Number button.
5Press ENT.
The Component button turns off.
Notes
•If you press a component code number that is not on the table in the supplied “Component Code Numbers”, or if you press a button in an improper order, the Component button flashes five times, and then turns off. Check the component code number, and try setting again.
•If you don’t input anything into the Commander for over 20 seconds between each step, the setup procedure will be canceled. To set the code, start over from Step 2.
•If you press S (set) while setting the component code, all code numbers will be lost, and the setup procedure will be canceled. Start over from Step 2.
To cancel setup, press S (set).
If the Component button flashes five times before turning off, it means that the setup is incomplete. Start over from Step 2.
Continued
9